5 . RENEW RUBBER WINDOW SEALS
TOOLS REQUIRED
• A couple of clean rags and some plain water ; and
• A spray can of silicon lubricant .
WHAT TO DO
Open all the windows . If any can ’ t be opened easily , do not force them open . Instead , spray some of the silicon lubricant over the seal and allow the lubricant to seep between the seal and the window .
Once all windows can be opened easily , clean each seal with the wet rag and allow it to dry .
Spray another clean rag with the silicon lubricant and wipe it all over the rubber seals . This will renew the rubber and ensure a weathertight seal with the window . It will also help prevent the seals from sticking to the windows .
HOW OFTEN SHOULD I DO IT ?
Once every six months or at least before and after every trip .
Using a cloth to clean the window rubber seals .
These trailer plugs get very dirty in no time at all . Regular maintenance will keep your van ’ s lights and brakes operating reliably .
6 . CHECK / REPLACE HOT WATER ANODE
TOOLS REQUIRED
• A new anode ;
• A socket set with a 1-1 / 16 or 27mm socket ;
• Some plumber ’ s tape ; and
• A hose .
WHAT TO DO
Isolate the van from the 240V power supply , turn off any water pumps and turn off the gas supply at the cylinder .
Remove any water pressure from the system by turning on a hot water tap until the water stops coming through . Then , locate the external access panel to the hot water system , open the cover , and locate the pressure relief valve and relieve any residual pressure by lifting the lever on the valve .
Remove the old anode using the socket set . The anode is usually located at the bottom of the system . Turn counter-clockwise to undo .
18 \